===Quick Start Instructions=== When the VetoDAQ app is first opened, the __Modify Veto DAQ Config__ window will pop up over the main app. When bias voltage, comments, etc. are entered, the operator clicks the button to exit saving changes, or to exit without saving. - After the Config vi closes, the main __VetoDAQv5x__ front panel will be visible - Before starting any DAQ loops, the mux backplane cards connected to the computer should be toggled to an OFF state, with none of the green backplane LEDs blinking - When ready to begin collecting data, the button is clicked again, programming the strobe pulse to be issued after a short delay (~5 sec). This starts the muxes - Click the buttons in the control clusters during the delay after the Toggle Mux button is clicked, but before the strobe occurs. - If the read process for a mux starts with a partial trigger packet at the front of the data read from the buffer, this is a framing error. The VetoDAQ application will detect this and correct it, but will display garbage in the counter displays for 2 seconds. The error should be detected on the first read, and a correction issued for the second read. From then on, it should be OK.