Go to the U of M home page
School of Physics & Astronomy
Assay and Acquisition of Radiopure Materials

User Tools

Trace:
vetoshield:gas

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
vetoshield:gas [2015/07/22 09:44] – [References and Additional Information] jeffvetoshield:gas [2015/07/29 13:15] (current) – [References and Additional Information] jeff
Line 252: Line 252:
 {{:vetoshield:mixer_control_board.jpg?700}} {{:vetoshield:mixer_control_board.jpg?700}}
  
-===Programming control=== +The CPLD configuration file is posted at the end of this manual along with the software written in LabVIEW.
- +
-[Joe is currently in the process of finding a copy of the CPLD programming to post right here. Upon repetitive failure to find the copy, this subsection will be omitted.]+
  
 ===Software Control=== ===Software Control===
Line 358: Line 356:
 ====References and Additional Information ==== ====References and Additional Information ====
  
-A backup of the Gas Mixer folder containing necessary software needed to run the controller.+A backup of the Gas Mixer folder containing necessary software needed to run the controller:
  
 {{:vetoshield:gas_mixer_2015-7-15.zip|}} {{:vetoshield:gas_mixer_2015-7-15.zip|}}
Line 365: Line 363:
 The main VI (mixer_controllerYYYY-MM-DD.vi) is included along with the necessary SubVIs. A copy of the pre-compiled executable along with a few helper files is alongside these files in another folder called “builds”. Also included are the necessary auxiliary files the controller needs access to which are the three log text files it writes to plus the config file "gas mixer.ini" and the mail list it reads from.  The main VI (mixer_controllerYYYY-MM-DD.vi) is included along with the necessary SubVIs. A copy of the pre-compiled executable along with a few helper files is alongside these files in another folder called “builds”. Also included are the necessary auxiliary files the controller needs access to which are the three log text files it writes to plus the config file "gas mixer.ini" and the mail list it reads from. 
  
-The LabVIEW code was written in LabVIEW 2012. If using the .exe instead of the VI, LabVIEW itself does not need to be installed but you must have the LabVIEW run-time engine (version 2012f3) and DAQmx 9.5.1 installed.+The LabVIEW code was lasted edited in LabVIEW 2012. If using the .exe instead of the VI, LabVIEW itself does not need to be installed but you must have the LabVIEW run-time engine (version 2012f3) and DAQmx 9.5.1 installed. 
 + 
 +The CPLD firmware is also included: 
 + 
 +{{:vetoshield:gas_mixer.zip|}} 
 + 
 +There is an up-to-date version of the .jed configuration file. The source code included is not the most recent version but is the only version I have been able to find. 
 + 
 + 
 + 
  
vetoshield/gas.1437576299.txt.gz · Last modified: 2015/07/22 09:44 by jeff

Page Tools