Differences

This shows you the differences between two versions of the page.

--- vetoshield:gas [2015/07/22 09:50] – [References and Additional Information] jeff
+++ vetoshield:gas [2015/07/29 13:15] (current) – [References and Additional Information] jeff
@@ Line 252: / Line 252: @@
 {{:vetoshield:mixer_control_board.jpg?700}}
-===Programming control===
+The CPLD configuration file is posted at the end of this manual along with the software written in LabVIEW.
-[Joe is currently in the process of finding a copy of the CPLD programming to post right here. Upon repetitive failure to find the copy, this subsection will be omitted.]
 ===Software Control===
@@ Line 358: / Line 356: @@
 ====References and Additional Information ====
-A backup of the Gas Mixer folder containing necessary software needed to run the controller.
+A backup of the Gas Mixer folder containing necessary software needed to run the controller:
 {{:vetoshield:gas_mixer_2015-7-15.zip|}}
@@ Line 366: / Line 364: @@
 The LabVIEW code was lasted edited in LabVIEW 2012. If using the .exe instead of the VI, LabVIEW itself does not need to be installed but you must have the LabVIEW run-time engine (version 2012f3) and DAQmx 9.5.1 installed.
+The CPLD firmware is also included:
+{{:vetoshield:gas_mixer.zip|}}
+There is an up-to-date version of the .jed configuration file. The source code included is not the most recent version but is the only version I have been able to find.